EZ112 is an amplifier for ON/OFF sensors and provides a relay output. It’s available as single channel (Z112A) or independent double channel (Z112D). The single channel dispose also of pulse division system (from 1 to 256). Also the lenght of pulse output is configurable from 100ms to 500ms. A 3-way galvanic isolation among Power supply // input // output circuits assures the integrity of your datas.

EZ112 is an amplifier for ON/OFF sensors and provides a relay output. It’s available as single channel (EZ112A) or independent double channel (EZ112D). The single channel dispose also of pulse division system (from 1 to 256). Also the lenght of pulse output is configurable from 100 ms to 500 ms. A 3-way galvanic isolation among Power supply // input // output circuits assures the integrity of your datas.

EZ113-1 is double alarm threshold with universal analog input and two relays common SPST 3 A@ 250Vac, 3 A@ 30Vdc. The input can be configured as voltage, current, potentiometer, thermocouples or thermoresistances. The current input can be set in passive or active mode in order to provide power to the sensor. EZ113-1 can be programmed by PC through a microUSB front connector where it is possible to configure the two alarm output, the input filter, the rejection and the burn-out. The isolation between input and power supply is 1500 Vac and 3000 Vac towards the outputs. On front panel status indicators are available for power on, out of range/burn out error and the alarm for each output.

EZ113D is a 2-CH relay output converter that accepts a programmable analog input for current and voltage signals. It's provided by stable power supply for transducers in 2-wire short circuit protection. Z113D allows to set the values of the set-point alarm, the delay time and hysteresis. The module allows to select the alarm type (minimum or maximum) for each set-point and relay status.

EZ113S is a 1-CH relay output converter that accepts a programmable analog input for current and voltage signals. It's provided by stable power supply for transducers in 2-wire short circuit protection. Z113S allows to set the values of the set-point alarm, the delay time and hysteresis. The module allows to select the alarm type (minimum or maximum) for each set-point and relay status.

EZ113T is a 3-CH relay output converter that accepts a programmable analog input for current and voltage signals. It's provided by stable power supply for transducers in 2-wire short circuit protection. EZ113T allows to set the values of the set-point alarm, the delay time and hysteresis. The module allows to select the alarm type (minimum or maximum) for each set-point and relay status.